7854 messages in 1577 discussions
Latest Mar-19 by Olivi
Latest Mar-18 by Klgh
Latest Mar-15 by 2KevR
Latest Mar-10 by langensiepen
Latest Mar-8 by Klgh
Latest Mar-5 by MarkLaCombe
631 messages in 129 discussions
Latest 6/11/18 by langensiepen
Latest Mar-19 by JuliaMMM
467 messages in 120 discussions
Latest Mar-14 by langensiepen
I have a bathroom with two vanities on two different walls. I'm trying to create an elevation to show both at the same time but there are 2 placement zones. How can I create an elevation showing both sinks and the tubs? Screenshot below.
I am not sure wich version you are using, but you can try following these steps:
- Select both areas pressing ctrl and double-click inside any of the areas selected.
- Or select both areas and go to Room Layout > Add elevation.
V11.9 has the option to present the 3 areas as a single elevation. Another method might be to replace the 2 middle walls with thickened panels (or 3D item).
V11.9 is the answer-it also is a great tool for Island elevations, etc.
Sorry about delay - was in UK for a bereavement. This is the solution for V11.9 onwards.