614 messages in 124 discussions
Latest May-16 by langensiepen
Latest Apr-27 by myostsr
421 messages in 107 discussions
Latest May-15 by MDancey
Latest May-1 by 9000RPM
7748 messages in 1543 discussions
Latest May-11 by KitchenGeek
Latest May-2 by langensiepen
149 messages in 51 discussions
Latest May-9 by quinsoto
824 messages in 188 discussions
Latest May-7 by Cabinetree
Latest May-4 by caboog
2088 messages in 499 discussions
Latest May-1 by MarkLaCombe
I'm having an issue when I try to view a perspective all I see is white. Top view is the same. In the past I would revert to a older saved file where I was able to view the perspective, (I try remember to do a "save as" and rename the file every hour ex. Smith 1.1) and recreate my work from there instead of starting completely over. Does anyone have any suggestions.
Try to select and copy whole project to a new file and save. May you have to select all finishes again, but is better than start from scratch.
The positioning of the camera is off. Double-click the wheel (yes, it is a button, too) or middle button somewhere in the whiteness. It should reorient to a position where you can see the rendering from above at an angle. Hope this helps!