2KevR

Kevin's Forum for Users of 2020 Design

Hosted by 2KevR|www.CatalogPros.com

A site for users of 20-20 Kitchen Design Software.

  • 2404
    MEMBERS
  • 16891
    MESSAGES
  • 0
    POSTS TODAY

Discussions

Wall Section   Version 9

Started Feb-23 by ArtKitchen; 195 views.
ArtKitchen

From: ArtKitchen

Feb-23

Hello all,

I had a request from the architect whom I work with asking to show the sections of the walls in the elevations. Example would be a room between two walls. When we view elevation of the middle wall, both return walls are not shown as they are not part of that elevation.

One way I used was to delete both return walls and extend the middle wall on both sides. But this would not show the inside vertical lines of those walls.

Another way was that I created 3D shapes on both sides and use them as return walls.

However, both methods included extra work and in high volume kitchens (116) these are not good solutions as they take extra work and time to be added to the design.

Is there any easy way that we can show the sections of those two return walls on elevations? If anyone has come across with the same situation?

Thank you.

EmtnCabGuy

From: EmtnCabGuy

Feb-24

If the version of 2020 you are using has Custom Elevations use that.  It will show your return walls.

ArtKitchen

From: ArtKitchen

Feb-29

Thank you.

I am using V9 which does not have that option of custom elevations.

TOP