580 messages in 121 discussions
Latest Feb-29 by ArtKitchen
2187 messages in 519 discussions
Latest 8:48 AM by Kamel42
Latest 8:40 AM by Kamel42
7918 messages in 1594 discussions
Latest May-28 by AngieSue (AngeLawrence)
Latest May-27 by stevenwm
840 messages in 193 discussions
Latest Apr-30 by joannacooke
I had a request from the architect whom I work with asking to show the sections of the walls in the elevations. Example would be a room between two walls. When we view elevation of the middle wall, both return walls are not shown as they are not part of that elevation.
One way I used was to delete both return walls and extend the middle wall on both sides. But this would not show the inside vertical lines of those walls.
Another way was that I created 3D shapes on both sides and use them as return walls.
However, both methods included extra work and in high volume kitchens (116) these are not good solutions as they take extra work and time to be added to the design.
Is there any easy way that we can show the sections of those two return walls on elevations? If anyone has come across with the same situation?
If the version of 2020 you are using has Custom Elevations use that. It will show your return walls.