This is intended for people interested in the subject of military guns and their ammunition, with emphasis on automatic weapons.
Latest 16:53 by stancrist
Latest 15:34 by roguetechie
Latest 10:47 by schnuersi
Latest 18-May by RovingPedant
Latest 18-May by TarheelYank
Latest 16-May by graylion
Latest 14-May by Farmplinker
Latest 14-May by autogun
Latest 13-May by Petrus_Optim
Latest 13-May by Mr. T (MrT4)
Latest 12-May by graylion
Latest 12-May by gatnerd
Latest 9-May by DavidPawley
Latest 9-May by taschoene
Latest 9-May by gatnerd
Latest 29-Apr by mpopenker
Latest 28-Apr by taschoene
Latest 28-Apr by autogun
Latest 24-Apr by taschoene
Latest 24-Apr by Mr. T (MrT4)
Latest 22-Apr by stancrist
Latest 22-Apr by gatnerd
Latest 20-Apr by roguetechie
A bullet like that is actually even lighter than my estimate, there being more nose cone and less shank.
The original EPR design used a bismuth core. Maybe the XM1186 solved the high temperature problem that plagued the 5.56 mm accuracy?
That would be worth modeling I think - if the steel EPR is ~125gr, whats the weight of the same projectile with the steel swapped for WC?
The back of this here enveloppe says 160 grains and change (with a density of 11.3)
@Emeric: perhaps, but the old bismuth-tin core M885A1 was pretty much the same shape as the eventual copper core EPR, so I would hazard a guess that that particular alloy's density is, like copper, 8.9 g/cm³. Pure bismuth is slightly more dense (9.8), but being rather brittle it's not a good material to make bullets out of. If they actually did manage a bismuth core bullet that would get you very close to 135 grains, but not quite.
While these first-gen FCS look bulky, this is single greatest upgrade to lethality
I imagine Elcan being free of ITAR will corner large chunks of the market.
Quick question about the textron 6.8.... am i to understand that only CT rounds can use compressed propellant?
Or could it be used elsewhere -for example- to reduce the size of a 556 round?
And can compressed propellant be combined with high case pressures?
5.7x28 is bottleneck.
Does being a bottleneck have any real effect on feeding reliability when we're talking about pointy, Spitzer projectiles?
I'd get the benefit for pistol rounds (.357 sig vs .40 using flat tip JHP) but for spitzer, the pointy tip is so much smaller then even a narrow .224 opening that I imagine bottleneck is pretty irrelevant.
Mr. T (MrT4) said:
Elcan being free of ITAR will c
Is that smart optic you're showing the new 'Smart ELCAN?' I had heard they were working on one but have never seen any specs or news on the project since.
Technically you can use compressed propellant in anything so long as you're using the right propellants.
Yes it's also compatible with High pressure though it's best to keep in mind that the higher you run your pressures the more similarity your cartridge has to a bomb if something goes wrong.
You definitely want to make sure that the guns action is rated to 25-50% more pressure than the peak pressure you want to run.