Polymer Clay Talk -  Help with baking time please! (245 views) Notify me whenever anyone posts in this discussion.Subscribe
From: Melody015/11/16 4:25 PM 
To: Melissa Sprout (MelissaSprou) unread  (6 of 7) 
 71289.6 in reply to 71289.5 

Melissa, I'd probably measure all the way from the bottom of the pea pod where the baby's "feet" would be up to the top of their heads. That's probably the measurement across the thickest "chunk/section" of PC. The timing isn't a "gotta be exact " type of thing. Assuming that you've checked your oven temperature with a separate thermometer for 30 minutes and tented to protect against browning (especially of light colors) you can cure much longer than the recommended directions. People often build a sculpture in pieces, curing, adding pieces using TLS, curing again, etc, so there shouldn't be a problems with curing a bit of extra time....just keep periodically checking for browning until you know what to expect from your oven. Hope this helps.

Anita in AZ







  • Edited May 11, 2016 4:27 pm  by  Melody01
 Reply   Options 

From: 7Jackie DelphiPlus Member Icon5/25/16 8:28 PM 
To: Melissa Sprout (MelissaSprou) unread  (7 of 7) 
 71289.7 in reply to 71289.1 

I'd bake that for an hour in a preheated (but you MUST have a separate oven thermometer in your oven to be sure of the temp!) 275 degree oven, in a baking pan, covered well.

We have to remember to cure our clay completely or it will break eventually.

If you are baking in a small oven (toaster oven), being sure no part of your sculpture is too near a heating element is important. I bake in my big home oven so it's not something I have to think about when I bake.

Good luck!




First Discussion>>

Navigate this discussion: 1-5 6-7
Adjust text size:

Welcome, guest! Get more out of Delphi Forums by logging in.

New to Delphi Forums? You can log in with your Facebook, Twitter, or Google account or use the New Member Login option and log in with any email address.

Home | Help | Forums | Chat | Blogs | Privacy Policy | Terms of Service
© Delphi Forums LLC All rights reserved.