Delphi Forums Member Services

Hosted by DelphiForums|www.delphiforums.com/support

The Delphi Member Services Forum is for all your membership issues including using Delphi, billing questions, bug reports, and suggestions.

  • 243718
    MEMBERS
  • 246392
    MESSAGES
  • 0
    POSTS TODAY

Discussions

Forum posting info   Navigating Delphi Forums

Started Nov-28 by Limoguy1953; 323 views.
Limoguy1953

From: Limoguy1953

Nov-28

I just joined the Yamaha 1300 V Star Forum and have a few questions. I'm not the most tech savvy guy around, so these questions might be laughable to a lot of folks...I'm  okay with that as long as someone takes pity on me and sends some advice.

Several people responded to my initial posts and I would like to thank them for the quick feedback. How do I respond to all of them at once and have it show up as part of the thread? So far, all I can figure out is how to respond to each one individually.

I saw a place to include an attachment with my post, but would like to have a picture of my bike appear at the bottom of every post. I suspect I would do that in my member profile, but I'm not sure how to access it or how to post the picture.

I would also like to include a signature line with all of my posts, is that done in the profile section also?

gunter

From: gunter

Nov-28

The forum is using the Classic interface so you can't reply to more than one poster or to: All, and then possibly thank everyone in the post.  Here in Service, which is set to Zeta,  you can add more names via +CC top right of the Reply screen, or use @ followed by the membername in the message itself.

It takes a paying membership to have a permanent sig, but you can always add images to each post via Insert Image icon on the toolbar.  Depending on your system, you may be able to drag and drop images from your computer into messages.
http://www.delphiforums.com/howto/insertImage.htm

membership comparison:
http://www.delphiforums.com/plans.ptt

sig:
http://www.delphiforums.com/howto/signatures.htm

let us know how it goes ...

  • Edited November 28, 2017 3:08 pm  by  gunter
TOP