_V Star 1100 Riders_

Hosted by Sick Mick* (quick_mick)|The V Star 1100 Wiki Knowledge Base

The Very Best Information Source for All Models of the V Star XVS 1100

  • 31544
    MEMBERS
  • 812669
    MESSAGES
  • 1
    POSTS TODAY

Discussions

Adding a Tacho   Tuning&Exhaust:99-05 non cal

Started Jul-6 by LordRamiro; 4071 views.
Donn (99Orton)

From: Donn (99Orton)

Jul-27

It's very possible to have 2 12vdc connections. You still don't know if it's for a dual fire system so even if you get it connected correctly it might not read properly. Good luck

In reply toRe: msg 24
LordRamiro

From: LordRamiro

Sep-14

ok Guys,

I finally had the chance to try the new cabling configuration I found on the amazon website sor My tacho.

Now they are talking about a high voltage signal.

Where on earth do I find such a wire ??

I tried the input AND the output of both coils and it doesn't budge an inch

I only managed to make the lights go on the darned thing.

( I might have asked though I don't remember)

Thanks in advance

Donn (99Orton)

From: Donn (99Orton)

Sep-15

I'm not sure how we can help anymore. I would have tossed that Amazon Chinese junk in the trash by now. 

Sick Mick* (quick_mick)
Host

high voltage signal wire is most likely a wire tapped into one of the plug wires...

LordRamiro

From: LordRamiro

Sep-16

Hey Mick

so I would have to "splice" a plug`s wire to get that high voltage ?

eruby

From: eruby

Sep-16

I think all you have to do is wrap that wire around the plug wire. I would not splice it in.

Sick Mick* (quick_mick)
Host

Some of the old and cheapie tachs required you to attach the wire to the spark plug terminal....basically removing the metal tip and crimping another one on with the tach wire included. On an 1100 that'll be fun because it's a special tip.

More modern better quality tachs just let you wrap the signal wire around the plug wire.....

In reply toRe: msg 30
LordRamiro

From: LordRamiro

Sep-17

What if I just twist it around the tip of the spark plug and put the connector back in ?

would it be a fire hazard ?

Sick Mick* (quick_mick)
Host

Well....you could try that I guess. Sure wish you had some instructions....

Donn (99Orton)

From: Donn (99Orton)

Sep-18

Remember if it isn't for a dual fire system it will probably give false readings or not work at all.

TOP