_V Star 1100 Riders_

Hosted by Sick Mick* (quick_mick)|The V Star 1100 Wiki Knowledge Base

The Very Best Information Source for All Models of the V Star XVS 1100

  • 31378
    MEMBERS
  • 811384
    MESSAGES
  • 8
    POSTS TODAY

Discussions

O-ribg removal mikuni carbs   Tuning&Exhaust:04cal/06 up

Started Oct-1 by seabird1974; 838 views.
seabird1974

From: seabird1974

Oct-16

Thank you for that answer. Was afraid something was wrong with the floats or something. When is the amount too much? I had never checked the elbows for fuel before so for me fuel in the inlet seemed like a problem

Hally1962

From: Hally1962

Oct-19

Mine do it on number 1 cylinder , it dont cause me a problem  but im tempted to put a compression  tester on it just to make sure the inlet valve is seating correctly 

seabird1974

From: seabird1974

Oct-20

Yes, for me also it is the number 1 cylinder. I figured it might be due to the lean angle on the stand but will investigate some more. 

Ordered a 1L fuel tank so I don't have to constantly install/remove gastank for testing.

I swapped out the float needle and O-ring just in case and will keep everyone posted once I figured it out

TOP