243 messages in 63 discussions
Latest 11/16/17 by srbstratton
437 messages in 115 discussions
Latest Oct-19 by srbstratton
Latest Sep-20 by LexArt
537 messages in 111 discussions
Latest Oct-16 by Hollenbeck
2108 messages in 503 discussions
Latest Oct-12 by banehforoosh
Latest Oct-4 by Hollenbeck
7800 messages in 1560 discussions
Latest Oct-2 by 2KevR
Latest Sep-25 by langensiepen
I am trying to remove the floor of a tall cabinet to be used as an open locker cabinet. I want to have this cabinet sit on a bench with a counter top and the counter top would be the "base" and be seen. I have taken the floor thickness on the cabinet to 0, but that doesn't make it go away. When I use a negative number it drops the thickness of the floor below the cabinet. I have tried to change the color to transparent but that didn't work. I have looked at every "floor" variable I could find and have not been able to figure it out. Any ideas?
ATone29 - try using a wall cabinet instead. Or try VFT=9999.
If you think a shape isn't responding properly, you can report it to 2020 Tech Support. If they agree, they can send you a cpsnew.zip catalog to install which will fix the shape in Common.
Ok, thanks! Good to know.....
The wall cabinet worked great! Thanks for all the help!!
It would be very handy if 2020 added a way to add a variable to an existing cabinet 'in flight' so to speak. e.g. if VFT isn't showing then being able to add it and then change it would be amazingly handy!